Tarmac Laying Contractor in Bincombe

Tarmac Laying Contractors in Bincombe — what to expect

Getting a new tarmac surface laid in Bincombe usually starts with the ground, and that is where the real skill shows. A proper contractor will strip back the old material, dig out any soft spots, and bring in a good layer of MOT Type 1 sub-base, which needs to be spread and compacted in lifts with a vibrating plate or a roller, depending on the size of the job. From there, the binder course—typically an AC 20 mix—goes down first, and this is what gives the driveway its structural strength, so it needs to be screeded and rolled while it is still warm. Once that has set, the surface course, usually an AC 10, is applied to give that smooth, dense finish that sheds water well and stands up to the Somerset weather. For paths and private roads around the TA5 area, the same principles apply, though the depth of the sub-base might be increased if you are running vehicles over it daily. If your existing tarmac is still in decent shape but has started to crack or fade, a plane and overlay is often the more sensible route, where the top layer is milled off and a fresh surface is laid, with a tack coat used to bond the new material to the old. Edge restraint kerbs and dropped kerbs are worth thinking about at the same time, as they keep the edges tidy and help with drainage, and a proper fall across the surface will stop puddles forming near your garage or front door. If you are in Bincombe and are weighing up a tar and chip drive for a farm track or a full tarmac job for the front of the house, it is always worth speaking to two or three local contractors to compare quotes before you commit.